WIRE AND CABLE INSPECTION
UL 1581 March 6, 1987
900.14 For the factory production continuity testing of a wire, the
manufacturer may elect to substitute either of the following for the test in paragraph
900.13: (1) a continuous eddy current procedure complying with paragraphs 900.15 and
900.16 or (2) a continuous differential capacitive current procedure complying with
The VERITEST® 4.0 is a basic eddy current flaw detector which is designed for continuous production testing of wire and tubular products. Typical defect detection includes laps, slivers, cracks, pits, and weld line faults in both magnetic and nonmagnetic materials.
The unit is also very effective in finding butt weld conditions and continuity variations on single and multi-conductor insulated wire and cable.
The VERITEST® 4.0 is typically installed on headers in the fastener industry, on recoilers on copper redraw operations, and on plastic extruding installations for electric wire manufacturers. When used on headers, they can detect hard areas which may cause breakage of punches, dies, and cutters.
Fixed frequency 100 Hz to 20Khz (application specific)
100 db range in 1 db steps
Test information: 100 segment bargraph
Threshold: 50% full scale (500 on digital display)
Fixed high and low pass
Selectable by module changes
Dry contact N/O N/C undelayed
Dry contact N/O N/C latched
Dry contact N/O N/C system energized
120 or 220 VAC, 50 or 60 HZ, 1 amp.
33 cm W x 90 cm H x 30 cm D
Weight 4 kg
* CUSTOM PACKAGING AVAILABLE *
>>Veritest 4.0 Power Point Presentation<
Engineered Inspection Systems
3259 Coral Ridge Road.
Brooks, Ky 40109
Tel: (502) 955-9021
Fax: (502) 955-7589
Email: EIS Info